Flo-Control Nozzle > Handyman Club of America

Site
Web

You are here: > > > >

Recent Member Tested and Recommended

Current Gear | Archives | Search

Flo-Control Nozzle MSRP: 99 cents


Member Tested Rating: 7.4


Share \|	\|	\|

The Flo-Control Nozzle (99 cents) is designed to stop overflow from silicones, adhesives and gap fillers applied with a caulking gun. The nozzle’s special chamber not only stops the contents from drying and blocking a container’s application tip; it also draws the material back through the nozzle and into the container when you’re finished, minimizing waste. The Flo-Control Nozzle screws into place and fits most caulking guns. Nevleck Pty Ltd., www.bostik.com.au

MEMBER TESTED RESULTS

BRYAN KELLY, SPRING, TX
Lifetime Member

“An excellent tool to stop sealants from dripping; I never even had to pick up a rag.”

ROBERT SMITH, PROSPERITY, SC
Lifetime Member

“Simple. It can be used again and again without getting clogged up.”

Comments

# bvanallen

Tuesday, September 21, 2010 6:20 PM

I got a wet drill bit that worked but got everything else wet and needed special tape to work at all. Now I'm being asked to pay a member fee of $300 that wasn't brought up when I signed up for this. Ok maybe it was in the fine print somewhere but I specifically remember seeing my membership was supposed to be a one time fee (which I all ready paid)! For $300 I might as well just go out an buy the tools I want and not get stupid wet drill bits that only half work!!!!!

Only registered users may post comments.